CCNA Certification (CCNA-Cisco network installation and support engineers) (Cisco Certified Network Associate) is a Cisco certification system as a whole the most elementary certification at the same time it is to obtain CCNP certification, CCDP, and CCSP certification a necessary condition for (CCIP Certification, CCIE Certification is not mandatory), and many Cisco professional certification (Cisco Qualified Specialist) also requires candidates must first CCNA certification.
In studying for your CCNA exam and preparing to earn this valuable certification, you may be tempted to spend little time studying static routing and head right for the more exciting dynamic routing protocols like RIP, EIGRP, and OSPF. This is an understandable mistake, but still a mistake. Static routing is not complicated, but it’s an important topic on the CCNA exam and a valuable skill for real-world networking. To install, configure and operate simple routed LAN, routed WAN, the definition of “simple” network content, such as IP, IGRP, IPX, serial, Apple, Talk, Frame Relay, IP RIP, IPX RIP, VLAN, in order to too much network and access to the lists.
To create static routes on a Cisco router, you use the ip route command followed by the destination network, network mask, and either the next-hop IP address or the local exit interface. It’s vital to keep that last part in mind – you’re either configuring the IP address of the downstream router, or the interface on the local router that will serve as the exit interface.